When ign switch goes to run, fuel pump should run. When ign goes to start pur/blk wire out of ign sw provides ground for start relay thru neutral start switch. Unplug neutral start switch and jumper two contacts in the plug together. That will provide gnd to the start relay. Power to start relay comes from the yel wire out of the ign sw when turned to start. At this point start relay should pull and provide power to spade connection on starter solenoid. If it doesn't pull, check yel wire going in for 12v and pur wire for gnd when key is in the start position. Also red wire going to start relay should be hot all the time. Start relay is on the frame rail near the regulator and ignitor.

Reply

Quote Reply

Digg It

Del.icio.us